15
Radiant Hotplates
The controls for the radiant hotplates may be set at any position between high and low to provide
the desire level of heating. An individual amber neon for each element, will glow when the element
cycles on and extinguish when the element cycles off.
Start cooking at the highest setting, and change to a lower setting when the desired temperature is
reached.
For maximum speed and economy, it is most important that cooking utensils should cover the
hotplate completely, and have perfectly flat bases. Any part of the hotplate which glows bright red is
not making effective contact with the base of the utensil, and this decreases the life and efficiency of
the hotplate.
Utensils which are significantly larger than the hot plate may also reduce hotplate life and efficiency.
Griddle Plate
Turn the thermostat control knob to the desired temperature. When the amber neon goes out, the
correct temperature has been reached and the griddle is ready for use.
Turning the control to a higher setting than required
will not
shorten the heat up time.
Operation
For the Refrigeration Cabinet Description of Controls, refer to the Refrigeration Cabinet Installation
and Operation Manual supplied with the appliance.
Summary of Contents for RN8400E
