13
Operation
Griddle
Lighting the Griddle
a. Depress gas control knob and rotate anti-clockwise to ‘Pilot’ position.
b. With gas control knob depressed, press piezo ignition button to ignite pilot burner. Repeat Items
1 to 2 until pilot is lit.
c. Release gas control knob approximately 10-20 seconds after lighting pilot.
d. Pilot should now remain alight - if not, repeat Steps (a to (c above.
e. ‘Full Flame’ can now be achieved by depressing and rotating gas control knob anti-clockwise to
first stop.
f. Low flame can be achieved by depressing gas control knob and rotating fully anti-clockwise to
‘Low Flame’ position.
g. When main burner is not required, depress and turn gas control knob clockwise to ‘OFF’ position.
Turning 'OFF' the Griddle Burner / Pilot
a. To turn griddle 'OFF', but keep pilot burner alight, rotate gas control knob to 'Pilot' position.
Griddle burner will extinguish and pilot will remain alight.
b. To turn 'OFF' 'Pilot, depress and turn gas control knob clockwise back to ‘OFF’ position. 'Pilot'
burner will extinguish.
Lighting the Oven Pilot Burner
This oven is fitted with a pilot as a standard option and flame
failure protection, which is incorporated by way of a thermo-
electric system for the main burner. Flame failure protection
will shut off gas supply to burner in the event that pilot burner
goes out, so that un-burnt gas is not expelled.
This is an
important safety feature which is slowly becoming law
throughout the world.
1. Open oven door. Partially depress thermostat control
knob whilst turning anti-clockwise to ‘Pilot’ position. DO
NOT fully depress Control Knob whilst trying to
rotate anti-clockwise as Knob and Gas Valve will
be damaged.
2. With thermostat control knob in ‘Pilot’ position, keep
knob depressed whilst pressing piezo igniter button.
(Each press of piezo igniter button will generate a single
spark).
3.
Hold in thermostat control knob for approx. 10-20
seconds, then release. Pilot burner should remain alight.
(If pilot does not light, repeat Items 1 to 3 above).
4. View oven pilot burner through holes in front of sole
plate with oven door open.
Griddle plate temperature reaches over 300°C in hottest points during normal
operation at 'Full Flame' setting
.
Caution
DO NOT USE aluminium foil or trays directly on cast iron
sole plate(s). NEVER block or cover openings on each
side of sole plate(s).
! IMPORTANT
Pilot Burner
viewing holes
Fig 4
Control Knob in
Pilot Position
Depress and Rotate Knob
Anti-Clockwise to Pilot Position
Piezo Igniter
Button
