18
2. With the cuff wrapped around your wrist, press the
START/
STOP button. Do not start the measurement process
unless it is wrapped around your wrist. All digits will light up,
checking the display functions. The checking procedure will
be completed after about 3 seconds.
3. After all symbols disappear, the display will show “00”. The
monitor is
“Ready to Measure” and will automatically
inflate the cuff to begin measurement.
4. When the measurement is completed, the cuff will deflate
entirely and systolic pressure, diastolic pressure and
pulse will be shown simultaneously on the LCD screen.
The measurement is
then automatically stored into
memory.
Note:
• This monitor automatically turns off
approximately
60 seconds after last
operation. You may also press the
START/STOP button to turn the unit
off or to interrupt measurements.
START
STOP