STEP 3 INSTALLING THE GLASS HOLDER
●
Insert the three glass holders
into the wall plate along the
wall plate rail at the desired
height respectively.
●Then tighten four screws with a 3mm Allen key as shown in
fig.3.1 to avoid wobbly situation.
●Insert two decorative covers to the top and bottom of wall
plate respectively and install six plastic covers
●You can adjust the height of the glass holders as needed.
Loosen the screws with a 3mm Allen key(but not remove) to
adjust the glass holders at the desired height and then
tighten screws with a 3mm Allen key as shown in fig.3.2.
fig.3.1
fig.3.2
adjustable in height
hide cable
fig.4.1
Assemble freely to
make one layer or
two layers
STEP 4 INSTALLING THE GLASS SHELF
●Place the three glass shelf gently on the three glass holders respectively. Attach the blass shelves to the glass holders
using screws and plastic bushes, tighten screws with a 3mm Allen key but not tighten completely at this time. Center the
glass shelves over holes, securely tighten screws with a 3mm Allen key as shown in fig.4.1.
fig.5.1
(DVD is not included)
STEP 5 CABLE MANAGEMENT
●After installing the DVD wall mount, place DVD gently on the mounted glass shelves. Pull out the cable clip,insert the cable
into any of the opening of the clip, with one head of the cable inserted in the clip, insert the clip into the main pole, take out
the other head of the cable from another opening of the clip, then push the clip until the end of the main pole.
●Once you have mounted the DVD bracket,Check that they are sufficiently secured andsafety to use.
You should check whether screws are fixed well every two months.
●If you have any doubts regarding the installation, please contact us at support@walielectric.com for details.
Maintenance
