Option A : Laptop Tray Installation
Option B : Monitor Mount Installation
Laptop Tray Holder
For safety, please remove your laptop when making adjustments.
7
Manually swivel, tilt, and rotate the monitor/laptop tray for the best viewing angle.
6
Guide the cable through the Wire Clips ( n1, n2 ) and store the Allen Keys o in the Wire Clip n1 .
Adjust the tilt angle using Allen Key 5mm n
.
n1
n1
o
o
n2
n2
15°
15°
ja
j
k
l
p
i
2b. Self-drilled Grommet Hole Installation
ø 10mm
(ø ")
3/8
o
Step 1
Select Monitor Screws
Step 3a
Flat Back Monitor
Step 3b
Curved or Recessed Back Monitor
e
e
r
s
q
M4x12
M4x30
4
Only one screw size fits your Monitor
Step 2
Select Spacers ( if needed )
Hand thread screws into the
threaded inserts on the back
of your Monitor to determine
which screw (M4x12 or M4x30)
to use.
5
Put the assembled laptop tray and TV/Monitor onto the Swivel Arms d . Tighten the VESA
Plate e with Nut h for stability.
e
d
h
o
n1
e
d
h
Mark the position of the hole on your mounting surface. Drill a 3/8"(10mm) diameter hole at the
marked position through the mounting surface. Position the Pole a on the mounting surface and
secure using the Support Plate j , M10 Washer k , Spring Washer l , and M10 Bolt i . Fasten the
Bolt using the provided Wrench p .
a
j
k
l
p
i
3
Put the Wire Clips n1 and Swivel Arms d through the Pole a , adjust the preferred height
and tighten using Allen Key 6mm o . Attach the Wire Clips n1 to the Swivel Arms d .
d
d
d
n2
n2
n1
n1
a2
a2
o
o
j
j
k
l
i
p
a
2a. Existing Grommet Hole Installation
If the existing grommet hole comes with a plastic protector, remove it to ensure a flat surface before
installing the desk mount. Position the Pole a on the mounting surface and secure using the
Support Plate j , M10 Washer k , Spring Washer l , and M10 Bolt i . Fasten the Bolt using
the provided Wrench p .
p
j
k
l
i
a
Select bolts and spacers (if needed) according to your TV/Monitor. Attach the VESA Plate to the Monitor and tighten with a screwdriver. (Screwdriver not included)
t
w
x
u
e
w
u
t
w
vv
e
Notice:
Please make sure the security nut is installed before you rotate the monitor.
h
h
Using M4 X 10 Bolt u and M4 Nut v to attach the VESA Plate e to the
laptop tray t and tighten with a screwdriver. Put the Anti-skid Pad on the
designated position on the tray. (Screwdriver not included)
e
w
t
v
u
