M002LM
WARNING
！
！
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
Measure the thickness of your mounting surface or desk
Option A : Clamp Installation
Option B: Grommet Base Installation
4A
4B
1
2
3
Dual Monitor Desk Mount
75x75\100x100
VESA Plate
A (x2)
Arm
B (x1)
C-Clamp
C (x1)
Pole
D (x1)
Pole Cover
E (x1)
Tool Holder
F (x1)
Grommet Base Plate
G (x1)
Anti-skid Pad
J (x5)
M3x7 Bolt
I (x2)
Nut
H (x2)
M6x12 Bolt
K (x3)
Support Plate
L (x1)
Allen Key 4mm
M (x1)
Allen Key 6mm
N (x1)
Allen Key 5mm
O (x1)
M4x12 Bolt
M-A (x8)
M4x16 Bolt
M-B (x8)
M5x12 Bolt
M-C (x8)
M5x16 Bolt
M-D (x8)
D5 Washer
M-E (x8)
Spacer
M-F (x8)
Fit clamp: 0.39”- 3.3”
Grommet: 0.39”- 3”
M
C-Clamp Brace
Clamp
M
K
D
J
M
0.39”-3.3”
Hand knob
G
J
D
E
Press Pole Cover
E
into the top of Pole
D
.
1.Connect Pole
D
and C-Clamp Brace from the bottom using M6x12 Bolt
K
and tighten
with Allen Key 4mm
M
.Tear off the protect paper and attach Anti-Skid Pads
J
to the
bottom designated position of C-Clamp Brace as image shown.
2. Connect C-Clamp to C-Clamp Brace using the bolts and tighten with Allen Key 4mm
M
.
Rotate the hand knob clockwise to fasten for stability.
1. Loosen the screw to release the hand
knob using a screwdriver as image shown.
(Screwdriver not included)
2. Tear off the protect paper and attach Anti-Skid
Pads
J
to the bottom designated position of
Grommet Base Plate
G
as image shown.
Loosen the bolts on C-Clamp
C
using Allen Key 4mm
M
.
INSTALLATION MANUAL
1-844-SATTLER (18447288537)
support@walielectric.com
www.walielectric.com
8kg/17.6lbs
RATED
MAX 27”
TIPOVER WARNING
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
Supplied Parts List
