21
5. Preparing the devices for use
WARNING
Strictly follow all notes on safety in these instructions for use.
5.1 Inserting powerpacks /batteries
• Open the battery compartment cover
• Insert the batteries (ensure correct polarity)
5.2 Mounting lamp on camera
• Mount the video lamp to the hot shoe on your camera.
(tighten the fixing wheel for tight hold)
5.3 Mounting lamp on tripod
• Turn the lamp with the ¼ inch thread on the corresponding spigot of a
lamp tripod
NOTE
Ensure secure fastening of the video light.
6. Using the video light
• Switch on the video light with the On/Off switch.
• Adjust the desired light intensity with the dimmer control.
• After use operate the On/Off switch to switch off the video light.
• Remove the powerpacks /batteries
7. Troubleshooting
Problem
Possible cause
Remedy
No video light
function
Power pack empty or
defective
Recharge the power
pack. Replace the
power pack.
The illuminant
does not light
The device is switched off
Switch on the device
The device has not
enough power
Increase the power of
the dimmer control
The device is defective
Repairs must only be
carried out by a skilled
electrician
8. Maintaining the device
Before each use check the LED video lamp with all its electronic compo-
nents for damage.
In case of damage have the device repaired by an electrician immediately.
18884man.indd 21
06.10.2014 14:40:36
