16
5. Operating the device
5.1. Device settings
I. Stand-by mode
• Press the on/off switch if you want to go to stand-by mode.
•
When in stand-by mode, the signal light fl ashes blue at specifi c intervals
II. Operating mode
• To activate operating mode, press the mode button and hold it down for 3 seconds.
• The gimbal starts stabilising. To switch back to stand-by mode, press the mode button again and hold
it down for 3 seconds.
III. Reverse mode
•
Use this mode to fi lm upside down. In stand-by mode, press the RIGHT button and hold it down for 5
seconds.
•
If the signal light fl ashes red, the Reverse mode is activated.
IV. Reset the device
• If you keep the DOWN button depressed for 5 seconds when in stand-by mode, a red signal light will
fl ash and the device will be returned to factory settings
V. Calibrating the sensor
• Balancing the platform by hand during the calibration process.
• In stand-by mode, press the LEFT button and hold it down for 5 seconds.
•
A green signal light will then fl ash. Once calibration is complete, the green signal light will turn red.
5.2 Energy display
Energy display
Energy display
75% - 100%
Flashes 4 times
50% - 75%
Flashes 3 times
25% - 50%
Flashes twice
Less than 25%
Flashes continuously
NOTE
Change the battery when the charge level is under 25% so that the performance of the device and the
stability of the platform will not be affected.
