OPERATOR’S MANUAL
9. Tighten the tip retaining fasteners starting with the center fastener and moving outwards,
alternating sides from the center to maintain the proper positioning until all fasteners
have been tightened to the required torque as specified in
Section 8: Specifications
.
Figure 7-33: Reference fastener tightening order
10. By hand, rotate the rotor counter-clockwise, as viewed from the driven end, for one full
revolution. Listen for any binding noise between the tip and casing; a light grinding noise
is normal and should disappear as the tip seats fully during the first few hours of normal
operation.
11. Repeat
Step 4
through
Step 10
for each blade until all tips have been adjusted. Check
the identifying numbers marked in
Step 4
to ensure each tip has been adjusted.
12. Check the positioning of the wiper blade with each tip. Polymer wiper blades should
contact each tip approximately 1/16 in (1.5 mm), and solid wiper blades should have a
clearance of 0.030 in to 0.060 in (0.76 mm to 1.5 mm), reference
Figure 7-2
and
Figure
7-3
. If necessary, refer to the section
Inlet Wiper Blade
for adjustment or replacement
instructions.
13. Reinstall or close any components that were removed or opened during adjustment and
ensure all guards are in place and secured.
MAINTENANCE AND ADJUSTMENTS
00-144477-0 A
7-31
Summary of Contents for Airlock 1008
