27
Pro Dry Instruction Manual
|
Walker Filtration
|
www.walkerfiltration.com
Section 6:
Maintenance
Figure 6.9: Controller reset
Resetting the Controller
•
After following the start-up procedure it is necessary to
reset the controller. This is done by using the re-set disc
(supplied with cartridge service kit) then:
•
Hold the disc against the blue pad on the front display of
the dryer panel for 5 seconds.
• During the five second period the power indicator will
flash green. When the reset has been successful indicator
X will flash green once to confirm that it has been
completed successfully.
Sweep the reset disc on the blue pad if the LEDs do not flash
as stated.
Please note: If Energy Management is activated, their will be
a 6 hour delay after reset before Energy Management will be
operational again.
Figure 6.10: Controller description
X
POWER
