31
Pro Dry Instruction Manual
|
Walker Filtration
|
www.walkerfiltration.com
Section 6:
Maintenance
GENERAL TOLERANCE SYSTEM - UNLESS OTHERWISE STATED
± 0.25 mm
=
0.0
0 NOM
0
=
= ± 0.50 mm
± 1.00 mm
REMOVE ALL SHARP EDGES
ASK! ALL DIMENSIONS IN mm.
DO NOT SCALE DRG. IF IN DOUBT
R
$format
DRG SIZE
SHEET
1
2
3
$sheet
$version
$ident
Figure 6.16: PD045 - PD085 Silencer changout stage 1
Exhaust Silencer Changeout
Models PD045 – PD085 only
•
Remove dryer front panel.
•
Unscrew silencer from bottom valve block and remove.
•
Replace with new silencer.
Important information
Ensure shutdown and start-up procedures are followed prior
to carrying out any maintenance work on the dryer.
Walker Filtration will not accept responsibility for physical
injury, damage or delays caused by failure to observe the
instructions in this manual and manuals provided with your
equipment.
