800-WMAGNET
8 of 33
3.1.3 Connecting the Chuck
The DC output to the chuck must include a ground wire that is connected to the safety ground lug on the chuck
and to the chassis of the chuck control. It is recommended that the conduit for the DC output not be routed
near high voltage AC wires. Many chucks are installed on machines with moving tables. Choose a means of
wiring the chuck that allows adequate freedom of movement over the full range of table travel.
3.1.4 Connecting the AC Input voltage
The input transformer can be tapped for nine different input voltages; 208, 220, 230, 240, 380, 416, 440, 460
and 480 VAC. Refer to the transformer wiring diagram Figure 3 2 on the following page.
Note
: that there are two (2) primary and two (2) secondary out put windings.
3.1.5 575 Volt Controllers
The transformer installed in Controllers designed to operate on 575 volts AC have a single primary winding.
Refer to the transformer wiring diagram Figure 3 2 on the following page.
3.1.6 Transformer Wiring Diagram
Figure 3-2 Transformer Wiring Diagram
Summary of Contents for IMI 100D
