24
Walker Magnetics, Inc., NEO Permanent Lifting Magnets
Never use a damaged or improperly functioning device!
WITH INSPECTION AND MAINTENANCE INSTRUCTIONS
NEO-HV 250, NEO-HV 500, NEO-HV 1000
OPERATOR’S MANUAL
AND
SAFETY INSTRUCTIONS
INSTALLATION OF THE HV LIFTING ARM
1 Take the end plate (4 socket head screws) off the slider.
2 Remove the lifting eye from the arm.
3 Insert the end of the lifting arm into the lifting eye of the magnet. The magnet’s operating lever should be on
the same side as the text plate of the lifting arm. (As shown if Figure 1 below.)
To expand your handling possibilities you can purchase Lifting arms, HV 250, HV 500 and HV 100
separately and retrofi t them to your NEO 250, 500, and 1000 lifting magnet. With the HV lifting arm
installed, the lifting magnet can be used for turning workpieces from the horizontal into the vertical
position and vice-versa. A very convenient means for loading and unloading of horizontal machining
centers and other machines. With this arrangement, the magnet can be adjusted to accommodate a
range of fl at plates & fl at circular disks.
A NEO-HV lifting device is comprised of one HV lifting arm (HV 250, HV 500 or HV 1000) attached to the
correct NEO lifting magnet (NEO 250, 500, or 1000).
Check upon delivery that the lifting arm is complete and undamaged. Apart from this manual the delivery of a
HV lifting arm consists of:
♦
The lifting arm HV 250, HV 500, or HV 1000 assembly and one allen key.
Figure 1
