54
Maintenance Instructions
ADJUSTMENTS
5.
If the forward travel is straight throughout the
speed range, except at maximum speed - place
the FSC in full forward, turn the set screw in the
Transmission Control Arm, of the faster side, in
until it contacts the hydro stud. (Turning the set
screw in slows the wheel.) Turn the set screw in
an additional 1/8 turn. Recheck for equal full for-
ward speed. Adjust this set screw until equal full
forward speed is achieved. Tighten the jam nut.
Neutral Travel End Adjust
Neutral Switch Adjustment - Step 6
1.
Place the FSC in neutral position. Loosen the
bottom lock nut and adjust switch body up with
top nut until the switch contacts open. Turn the
nut an additional 1 turn. Tighten lower nut.
FSC Switch Location
Forward Speed Control Friction Adjustment - Step 7
FSC Position With Levers
1.
Place the FSC in the full forward position and
pull both steering levers back; the FSC lever
should not move. If the FSC lever moves back
the friction needs to be increased.
2.
With the steering levers held back, move the
FSC lever back from the forward position. With
a proper amount of friction adjusted, the FSC le-
ver should move back with a slight amount of re-
sistance (friction). If the FSC lever movement is
"stiff", the friction needs to be decreased.
3.
The FSC friction is increased or decreased by
tightening or loosening the friction adjustment
nut. Loosen or tighten the nut and check the
control function until the conditions of both
steps 1 and 2 are met.
FSC Switch
