64
Maintenance Instructions
ADJUSTMENTS
Steering Handles Adjustment - Step 2
1. An adjustment range of approximately 3 in.
(76.2 mm) is available on the steering handles
- the han dles can be adjusted forward or aft
depending on the arm length of the operator.
The handles can be adjusted by loosening the
locknut at the pivot point and the locknut holding
the handle in position in the adjustment slide.
Adjust the han dles into the most comfortable
position and tighten both locknuts.
Adjustment
Slide
Locknut
(Position)
Locknut
(Pivot Point)
Steering Lever Adjustment
Neutral Position Adjustment - Step 3
1. With the Forward Speed Control (FSC) in
NEU-
TRAL,
the lever should be straight up. Adjust
by loosening the jam nuts on the FSC Rod and
turn the rod to attain the straight up position.
Tighten the jam nuts.
FSC Position
4 in.
(101.6 mm)
Steering Adjustment
2. The initial adjustment for neutral is to loosen the
jam nuts on each end of the Hydro-Gear Control
Rods and turn the rods to achieve a measure-
ment of 4 in. (101.6 mm) between the jam nuts.
Be sure to tighten jam nuts before making the
measure ment.
