ASSEMBLY
OM 0182SB-A
15
Installation of Electric Chute Rotation Kit 9475 (Option)
(Figure 14 and Electrical diagram)
1.
Insert 1 11/16" (43 mm) plastic bushing
(item 1) in rotation bracket (item 2).
2.
Install the worm adaptor (item 3) on the
motor shaft and attach motor (item 4) to
electric motor support (item 2) using three
1/4" x 2" bolts, spacer rings (item 7) and 1/4"
nylon insert lock nut (item 13). Secure the
motor on shaft with two allen setscrews 1/4"
NF x 1/4" (item 8). Tighten securely.
3.
Insert longest tube end of rotation worm
(item 5) over worm adaptor (item 3) and into
plastic bushing in electric motor support.
Align holes and secure with a 10-24 NC x 1"
capscrew (item 10) and a nylon lock nut
(item 11). Tighten securely.
4.
Install the chute over the anti-friction ring and
place the four retaining plates (item 6).
Secure with two 1/4" x 3/4" bolts (item 14),
5/16" flat washers (item 15),
lockwashers (item 16) and nuts (item
17), in the rear left retaining plate which
also secures the electric motor support
assembly on the underside of chute
base lip. Attach the three remaining
plates with six 1/4" x 1/2" bolts,
lockwashers and nuts. Torque to 9-11
lbs-ft (12-15 N-M).
5.
Drill a 1/2" (13 mm) hole in tractor for
control switch. Drill a .593" (15 mm) hole
at least 2 1/2" (63.5 mm) from control
switch hole for fuse holder. The two
holes must be drilled in an appropriate
location and must not interfere with
existing controls or electrical system.
6.
Solder one 18" (457 mm) wire to side
terminal of fuse holder and the other 18"
(457 mm) wire with eyelet to bottom
terminal.
7.
Install switch and fuse holder. Thread
rubber protector over switch.
8.
Connect the eyelet of the 18" (457 mm)
wire to
"B"
terminal of control switch.
9.
Connect one end of the 17" (432 mm)
wire to
"E"
terminal on control switch
and the other end to a suitable ground
on tractor frame.
10.
Connect one end of a 5" (127 mm) wire to
"A"
terminal and other end to
"D"
terminal
on control switch.
11.
Connect one end of other 5" (127 mm) wire
to
"C"
terminal and other end to
"F"
terminal
on control switch.
12.
Attach eyelet of the double wire to
"A"
and
"F"
terminals of switch.
13.
Connect fused wire to wire from tractor
ignition switch
"AC"
terminal using the
connector tap.
14.
Connect free end of double wire to electric
motor. Cut this wire at a convenient location
for blower removal. Install the connector to
the motor half of the wire.
15.
Secure wires away from moving parts using
the provided tie wraps.
Figure 9
Figure 14
Electrical Diagram
