Assembly Instructions
17
SETUP INSTRUCTIONS
Walker Mowers are shipped partially assembled to
our distribution network, and are typically assem-
bled by the selling dealer. For any additional as-
sembly besides the following, contact your Walker
dealer.
Battery Service
Check the battery for electrolyte level and charge.
The electrolyte level should be at the bottom of the
vent wells [1/4 to 1/2 in. (6 to 13 mm) above plates].
If the specific gravity is less than 1.225, the battery
needs charging. If the battery has been shipped dry,
or is wet but needs service, refer to the following
instructions.
Battery Location
IMPORTANT:
Make sure battery is securely mount-
ed in the frame. A loose battery may cause damage
to the case resulting in acid leakage and severe
damage to the machine. A hazard may be created
by damage to critical working parts and safety sys-
tems.
Wet Battery Service
If the battery has been shipped wet, but the electro-
lyte level is low or the battery needs to be charged
then:
1. Fill each battery cell with distilled water to the
bottom of the vent wells.
2. Charge battery. Refer to
Battery Charging
in
this section.
Dry Battery Service
DANGER
Activating a battery can be dangerous.
The battery should be taken to a reliable
service station, battery store, or power
equipment dealer where a trained techni-
cian can activate the battery safely. DO
NOT attempt to activate the battery unless
you are experienced in battery service
work. The following activation and charg-
ing instructions are provided for use by a
trained battery technician.
DANGER
Battery electrolyte is a poisonous and cor-
rosive sulfuric acid solution.
•
Avoid spillage and contact with skin,
eyes, and clothing - causes severe burns.
•
To prevent accidents, wear safety gog-
gles and rubber gloves when working with
electrolyte.
•
Neutralize acid spills with baking soda
and water solution.
To fill (activate) battery with electrolyte (if battery has
been shipped dry):
1. Remove the battery cover plate, disconnect the
battery cables and lift the battery out of the tray.
IMPORTANT:
Battery must be removed from
the mower before filling with electrolyte.
IMPORTANT:
Obtain and use only battery
grade sulfuric acid electrolyte with a 1.265 spe-
cific gravity to activate the battery.
DO NOT
use
water or any other liquid during initial activation.
2. Remove the filler caps and carefully fill each cell
until the electrolyte is just above the plates.
3. After the battery is filled with electrolyte, replace
the filler caps and charge the battery. Refer to
Battery Charging.
Summary of Contents for B18
Page 73: ...69 Operator s Notes...
Page 74: ...70 Operator s Notes...
