English
- 11 -
Initial Settings
When the TV is turned on for the fi rst time, the menu
for the language selection appears on the screen. The
message “
Welcome please select your language
!”
is displayed in all language options sequentially in
the OSD.
By pressing the “ ” or “ ” buttons highlight the language
you want to set and press
OK
button.
You can get information about the menu usage by
pressing
INFO
button. Press
INFO
button again to
exit the help menu.
After then, “
First time installation
” OSD will appear
on the screen. By pressing “ ” or “ ” buttons, select
the country you want to set and press
OK
button.
Note: Country selection will not be available for UK.
Press OK to continue.
After then, the active antenna selection OSD appears
on the screen:
By pressing “ ” or “ ” buttons, set active antenna
mode as on or off.
If an active antenna is connected to your TV, you can
select this option as On. Antenna power should be
“Off” when standard antenna is used instead of the
active antenna. See “
Confi guration Menu
” in the
following sections for more information.
Press
OK
button on the remote control to continue
and the following message will be displayed on the
screen:
• To select the “Yes” or “No” option, highlight the item
by using “ ” or “ ” buttons and press
OK
button.
The IDTV will automatically tune to the transmission
channels, searching for digital terrestrial TV broadcasts
and displaying the names of channels found. This
process will take a few minutes. To cancel searching,
you can press
M
button at any time during the
process. The following OSD will be displayed during
the automatic search:
After Automatic Search is completed, the following
message will be displayed, asking for sorting option.
If you select
“YES”
, programme list will be sorted
according to LCN (logical channel number). Select
“NO”
for using frequency sort. (This feature is
available for only Germany,Austria and Italy country
option)
After this operation, the following menu will appear
on the screen, asking for analog channel search:
To search for analogue channels, select “Yes”. TV
switches to the analogue TV mode. A menu will be
displayed to search for analogue channels.
Set
Language
item by pressing “ ” or “ ” button.
Press “
” or “
” button to highlight
Country
item and
then use “ ” or “ ” to set. Press “
” or “
” button to
highlight
TXT. Language
. Set TXT Language by using
“ ” or “ ” button. To cancel, press the
BLUE
button.
When fi nished, press
OK
or
RED
button to continue
and the following OSD will be displayed:
After
automatic tuning
is fi nalized, a programme list
will appear on the screen. In the programme list you
will see the programme numbers and names assigned
to the programmes.
If you do not accept the locations and/or the names
of the programmes, you can change them in Program
table. For details, see the section, “Program table”.
General Operation
Pressing the
TV/DTV
button at any time while
watching television programmes will switch the TV
01_MB37_[GB]_19880W_1205UK_IDTV_BRONZE13_10066749_50160784.indd 11
01_MB37_[GB]_19880W_1205UK_IDTV_BRONZE13_10066749_50160784.indd 11
15.12.2009 13:26:00
15.12.2009 13:26:00
