Walker WP3211LCD, Operating Instructions Manual

English   

- 4 -

 Warning 

 Do not leave your TV in standby or operating mode 
when you leave your house. 

Connection to a Television 
Distribution System (Cable TV etc.) 
from Tuner

Device connected to the protective earthing of the 
building installation through the mains connection or 
through other apparatus with a connection to protective 
earthing-and to a television distribution system using 
coaxial cable, may in some circumstances create a 

fi

 re hazard.

Connection to a cable distribution system has 
therefore to be provided through a device providing 
electrical isolation below a certain frequency range 
(galvanic isolator, see EN 60728-11).

  Inserting Batteries in the 
Remote Control Handset

  • Remove the battery cover located on the back of 

the handset by gently pulling backwards from the 
indicated part.

  • Insert two  

AAA/R3

  or equivalent type batteries 

inside.Observe the correct polarity (+/-) when 
inserting batteries and replace the battery cover. 

Note

 : Remove the battery from remote control handset when 

it is not to be used for a long period. Otherwise it can be 
damaged due to any leakage of batteries. 

Remote range is approximately 7m/23ft.

  Switching the TV On/Off

  To Switch the TV On

  • Connect the power cord to the 220-240V AC, 50 

Hz.  

 • Press  “

”  switch. Then the standby LED lights 

up. 

 • To switch on the TV from standby mode either:
  • Press the “

” button,  

P+

 / 

P-

  or a numeric button 

on the remote control. 

 • Press the  

-P/CH 

 or  

P/CH+ 

 button on the TV. The TV 

will then switch on. 

Note: If you switch on your TV via standby button on the 
remote control, the programme/source that you were 
watching last will be reselected.

 By either method the TV will switch on. 

 To Switch the TV Off

  • Press the “

” button on the remote control or press 

the  “

” switch, so the TV will switch to standby 

mode. 

 •  

To power down the TV completely, unplug the 
power cord from the mains socket.

Note: When the TV is switched to standby mode, 
standby LED can blink to indicate that features such 
as Standby Search, Over Air Download or Timer is 
active.

[GB]_MB36_MASQUE_HDIDTV-MPEG4_BRONZE8_32843W_1205UK_10069999_50176032.indd   4

[GB]_MB36_MASQUE_HDIDTV-MPEG4_BRONZE8_32843W_1205UK_10069999_50176032.indd   4

06.09.2010   09:12:03

06.09.2010   09:12:03