Walker WP4212LCD, Operating Instructions Manual

- 11 -

Using Side AV Connectors

You can connect a range of optional equipment to 
your LCD TV.

For connecting a camcorder, connect to the VIDEO 

• 

IN socket and the AUDIO SOCKETS. For selecting 
the related source, see the section “Input selection” 
in the following parts.
To listen the TV sound from headphones, connect 

• 

to the HEADPHONE jack of theTV.

Using Other Connectors

You can connect a range of optional equipment to your 
TV. Possible connections are shown below. Note that 
cables shown in the illustration are not supplied.

For connecting to a device that has SPDIF support, 

• 

use an appropriate SPDIF cable to enable sound 
connection.

External  Speakers

A  device  that 

supports 

SPDIF  signal.

Remote Control Handset

Inserting Batteries

Remove the battery cover located on the back of 

• 

the handset by gently pulling backwards from the 
indicated part.
Insert two 

• 

AAA/R3

 or equivalent type batteries 

inside. Observe the correct polarity (+/-) when 
inserting batteries and replace the battery cover.

Note: Remove the batteries from the remote control 
handset when it will not be used for a long period. 
Otherwise it can be damaged due to any leakage of 
batteries. Remote range is approximately 7m/23ft.

Switching On/Off

To Switch the TV On

Connect the power cord to the 220-240V AC, 50 Hz. 

• 

Switch the “

• 

” button to position “

|

” so the TV 

will switch to standby mode. Then the standby LED 
lights up.
To switch the TV on from standby mode either:

• 

Press the “

• 

” button, 

CH 

“ ” / 

CH 

“ ” or a numeric 

button on the remote control.
Press the 

• 

-P/CH

 or 

P/CH+

 touch button on the TV. The 

TV will then switch on.

Note

: If you switch on your TV via 

CH 

“ ” 

/ 

CH 

“

”

 buttons on the remote control or on the TV set, 

the programme that you were watching last will be 
reselected.

To Switch the TV Off

Switch the “

• 

” button to position 2 as illustrated, 

“

” so the TV will switch 

OFF

.

To power down the TV completely, unplug the 

• 

power cord from the mains socket.

Note: When the TV is switched to standby mode, 
standby LED can blink to indicate that features such as 
Standby Search, Over Air Download or Timer is active. 
The LED can also blink when you switch on the TV from 
standby mode.

01_MB65_[GB]_DVB-TC_PVR_BRONZE18_1910UK_42843W_10076242_50202610.indd   11

01_MB65_[GB]_DVB-TC_PVR_BRONZE18_1910UK_42843W_10076242_50202610.indd   11

04.11.2011   11:18:46

04.11.2011   11:18:46