9
(1) Please use manual mode to start to fly, switch to one key go home mode the aircraft begin to return home,
after landing to the ground and push the throttle stick to the lowest position,the motors would lock automatically,and
later need to re-switch to manual mode the motors can unlock.
9.3.2 The flowchart of One Key Go-Home
9.4 Failsafe to Return & Landing
(2) To make sure the safe useage, please make sure to record the starting position before departure and know
exactly where the starting position is.
(5) When GPS signal is bad or GPS is unable to work, the failsafe will not work and the aircraft will not return.
9.3.3 Notes
(3) When return home the aircraft straight flight along the line on the horizon which between the start position
and the failsafe point.
9.5 Low Voltage Protection
Low Voltage Protection is a design to avoid the aircraft to crash by the low voltage of the battery.
When the battery voltage is too low, the left green LED will slow blink warning, the aircraft will descent slowly.
09
Advanced
function
specification
(4) The aircraft may be stuck if there are big obstacles around or windy conditions.
It is a protective measure that prevents aircraft from missing signal and out of controlling. When aircraft
lose control signal, it can enter Failsafe go home automatically.
Attention: The voltage alarm will be reminding when the aircraft at fixed point and fixed height or one key return
mode, please switch to manual mode to control as soon as possible.
Record return position
Ground
Aircraft
Ready for
go back
Record return position
Hover
MIX Switch
to“2”Position
Keep MIX Switch
to“2”Position
Keep MIX Switch
to“2”Position
Keep MIX Switch
to“2”Position
Ruturn position
First Hover then Landing
1
2
3
4
5
6
Actual Go back
landing range(Relate
to the GPS signal)
