-15-
11.2 TX5834(FCC)/TX5835(CE) Video transmitting channel selection
Port introducton
1. Position of 5.8G antenna
2. Transmitter code switch
3. OSD code switch
There are 8 channels avilable, chose the best channel based on the image quality on your screen.
Select the channel by adjusting the dip-switches on the video-transmitter according to the diagram.
Video transmitting channel selection
Attention:
Attention:
Video transmitter channel must match the reciever channel.
11.3 OSD interface information Introduction
The OSD information is visible on your video reciever.
* Goggles or screen with video reciever.
When the arrow points straight down,
pull back the ELEV stick, then the drone will fly back to Home position.
OSD code switch from “1” to “ON” to start the OSD.
O N
3
2
1
O N
3
2
1
O N
3
2
1
O N
3
2
1
O N
3
2
1
O N
3
2
1
O N
3
2
1
O N
3
2
1
1
5847MHz
5828MHz
5809MHz
5790MHz
5771MHz
5752MHz
5733MHz
2
3
4
5
6
7
8
Channel
Frequency
Code
position
(on/off)
5866MHz(CE)
5847MHz(FCC)
1.5
M
S
/
20
M
h
/
30M
10M
10
12.6V R 15°
P 15°
E NG
10:00
200°
Horizontal distance
Timer
Front
Angle
ROLL
PITCH
Number of satellites
The yaw angle
Flight height
Horizontal
flight speed
ascend/descend
speed
Home point
Arrow direction indicating the angle
between the aircraft’s tail and
Home points
The aircraft battery volume
Remote Controller
battery volume
Quick Start Guide
