Walkera V1100 PRO, Quick Start Manual

10

Walkera All Rights Reserved

V1100 PRO

  Quick Start Guide

※

 Please turn on the remote controller to check the battery level. Be sure to fully charge the battery for the first time of use.

Method:

     Press and hold the ON/OFF button on the remote control for 2~ 3 seconds to turn on the remote control.

5.0  Check Battery Level

1) Please charge with the remote control turned off.
2) The green light on the remote control charging complete indicator

    is on --- it means it is fully charged.

6.1 Charge the remote control

There are two ways to charge the remote control battery 

rechargeable battery:

Method one:

Without removing the battery, use a DC15V 4A power adapter 

to directly connect to the charging port of the remote control 

for charging.

Note: The input power of the DC15V 4A power adapter is 100~240V 50/60HZ AC.

Fig. 6.1-1

Charging port

6.0  Charge

1) To charge with the GA008 charger, the battery must be removed from the remote control, as shown in Figure 6.0-2.
2) Connect the remote controller battery, GA008 charger, 15V 4A power adapter to charge as shown in Figure 6.0-3.
3) The GA008 charger indicates that the red light is always on --- means charging, and the green light is on --- means it is fully charged.

Method two:

Charge with GA008 charger.

Fig. 6.1-3

Finished charge 

green indicator

Charging Red 

indicator

Fig. 6.1-2

Press the buttons on both sides 

and remove the battery upward

Level

Low

High

Fig. 5.0

Tips: 

Pls. remove battery from the remote control and charge the battery by GA008 charger 

in order to shorten the charging time of the battery.