Walkera ZHUN WK-1800, Quick Start Manual

Operating steps

1) Power on: Connect the aircraft to AC mains and turn the power switch on. The charger will sound a “Beep”, the 
    fan will rotate once for self-test, and the LCD will show the following screen.

2)Connect the battery: Please connect the battery and charger according to the diagram as shown below:
   (Note: The number of lithium batteries that support charging is 12; the battery charging cable and the balance 
   port must be connected to the charger at the same time; the charger can charge two sets of batteries at the 
   same time.)

①

Connect the balance charger cable as shown by the red arrows.

②

Connect the battery charging cable as shown by the blue arrows.

3) Start charging: press and hold     and     at the same time for 5 seconds until the battery type shown on the screen 
    is LiHv. Press and hold     for 2 seconds and then press     to confirm to start charging.

Fig. 6.2-1

Fig. 6.2-2

11

Walkera All Rights Reserved

WK-1800

 Airborne dry powder fire extinguisher

, Fire Hose Fire Fighting UAV Quick Start Guide

6.2 Charge the aircraft lithium battery

Battery Type(LiPo/LiHV)

Charging current (1.0-12.0 A)

Charging mode (fast charge, precise charge, battery storage)

Sync status(Off-line, Master, Slave)

12.0A

LiPo

FAST CHARGE

Off-line

Fig.6.2-3

Fig.6.2-4

选项

设置

/

停止

确认

/

开始

START

STATUS

STOP

LiPo

LiHV

12 .0 A

FAST CHARGE

FAST CHARGE

Off-line

Off-line

12 .0 A

锂电池

12.0A

快速充

单机

锂电池

12.0A

快速充

单机

①

①

②

②

6.3 Laser-assisted sight battery charging

1) Unscrew the auxiliary sight back cover counterclockwise to remove 

     the battery.

2) Align the negative pole of the battery with the negative slider of the 

    charger and snap the battery into the charger.

3) Connect the charger to the AC power supply (100~240V, 47~63 Hz).

4) The charger indicator turns green means charging full.

5) After charging is completed, the positive side of the battery faces 

    forward,the negative side towards the back cover and fitted back 

     into the laser-assisted sight.

Tip: This device has built-in 3.6V 2600mAh 18650 lithium battery. Please use the original charger for charging. 

        When charging, Positive battery docking charger positive, negative battery docking charger negative.

       Do not reverse the positive and negative terminals of the battery.

Fig.6.3-1

Charging Indicator