Walker's ATACS, Instruction Manual

Page 10

FCC Statement:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 

conditions. (1) this device may not cause harmful interference, and (2) this device must accept any 

interference received, including interference that may cause undesired operation.

FCC Caution:

Changes or modifications not expressly approved by the party responsible for compliance could void 

the user’s authority to operate the equipment.

NOTE

: This equipment has been tested and found to comply with the limits for Class B digital device, 

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates, uses, and can 

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio or television receptions, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the interference by one or more of the 

following measure:
• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected.
• Consult the dealer or an experienced radio/TV technician for help.

Shielded interference cable must be used with the equipment in order to comply with the limits for a 

digital device pursuant to Subpart B of Part 15 of FCC Rules.

Specifications and designs are subject to change without any notice or obligation on the part of the 

manufacturer.

The Device has been evaluated to meet general RF exposure requirement. The Device can be used in 

portable exposure condition without restriction.

IC NOTE

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science 

and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following 

two conditions: 
1.  This device may not cause interference.
2.  This device must accept any interference, including interference that may cause undesired 
operation of the device.

FCC Compliance

GSM, LLC
GWP-SPEB

FCC ID: 2AU3A-GWPSPEB
IC: 25750-GWPSPEB