background image

one area to another) without spraying, pull 
backwards, or switch the valve on the 
handle to the off position. 
 
 

PRECAUTIONS 
 
 

The manufacturer sets the pump 
mechanism. Any tampering with the pump 
setting may change the performance of 
your machine and will render your 
guarantee void. 
 
Some of the chemicals that can be applied 
by this machine onto grass areas and 
driveways require special precautions for 
use. Protective clothing including boots, 
gloves and masks may be necessary and 
therefore individual manufacturer’s 
recommendations for the particular 
chemical must be closely adhered to. 
 
WALKOVER Sprayers Ltd. disclaims any 
responsibility for misuse of any proprietary 
brand of chemical applied by a machine of 
their manufacture. All reasonable care is 
taken to ensure correct dosage application 
of known chemical formulations but 
Walkover do not guarantee either their 
efficiency or accept any responsibility or 
damage resulting from user’s mistakes in 
assessing dilution rates. 
 
Experience has shown that combined 
mixes of chemicals, i.e. fungicides and 
weed killers, can often interact, resulting in 
the formation of gelatinous substance 
which can crystallise if left in the machine 
after use. This solidifies within the pump 
and nozzles and can in extreme instances 
completely destroy the pump mechanism. 
Many propriety brands of garden and 
horticultural chemical are sold in the form of 
Soluble powder or Crystals.  
 
The

 

RAMBLER

 sprayer

 

will satisfactorily 

apply these chemicals always providing 
that the crystals or powder are 

completely

 

pre-mixed 

before

 adding to the sprayer 

tank  and assuming that the chemical in 
question is 

entirely soluble

 

NEVER

 leave a soluble powder or a crystal 

solution, or even an organic product, to 
stand in the machine for any period of time 
as sediment may form in the system and 
the concentration being applied may be too 
strong and cause scorching. It may also 
find it’s way into the pump mechanism 

causing damage to the seals or internal 
components. 
 

DO NOT mix proprietary brands of 
chemicals or treatments unless assured 
of their compatability. 

 

Please Note.

 Powder or crystalline 

substances which require diluting & mixing 
( not liquid concentrates ) such as sulphate 
of iron should be used with caution.  
 
Treatments that have not been thoroughly 
mixed or that have been allowed to settle in 
the tank can damage your sprayer because 
such materials are abrasive. Please 
exercise care and flush your sprayer 
thoroughly after use. 

 

 
 
 
 
 
 
 
 
 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Summary of Contents for Yardmaster















Reviews: