FoldSmart™ Installation and Maintenance Manual
Revision 1 - MAY 2023
119
OPERATION NOTES
Four wires to the receiver and two wires to the emitter are all that is required.
•
Depending on how the photo eyes are to be wired, +24VDC or +12VDC power is provided via spades
located just to the right of the COM terminal strip near the left side of the board.
•
The receiver common wire is connected to the SENSOR COM terminal at the bottom left of the
SmartDC Controller.
•
The photo eye NC output wires connect to the SmartDC Controller at the appropriate Sensor Input
(1, 2, or 3).
Summary of Contents for FOLDSMART
