42
wallaceperimetersecurity.com
Phone: 866.300.1110
INSTALLATION ADJUSTMENTS
3.
Once the covers are removed, identify the
open and closed limit switches.
The limit
switch furthest from the gate panels is
always the closed limit switch, no matter the
handing of the gate.
4. Each switch will have a cam that will rotate
on the limit hub and activate its switch at the
appropriate position.
5.
To adjust a limit, use a #2 Phillips screwdriver
to loosen the screw holding the cam in place.
You do not need to remove the screw entirely.
7.
When adjusting the cam(s), a small amount
of adjustment will result in a much larger
adjustment to the limit position of the gate
panels. It is helpful to do the initial testing
by moving the gate panels manually or via
the open/close push-buttons on the SmartDC
control board. This will allow easy access to
the Stop button in case the limit has been
overset.
6.
Once the cam can move freely, adjust it to
the required position on the limit hub and re-
tighten the Phillips screw. Do not overtighten
the screw.
Summary of Contents for FOLDSMART
