54
wallaceperimetersecurity.com
Phone: 866.300.1110
USING THE SMARTDC CONTROLLER BUTTONS IN MENU MODE
Using the SmartDC Controller Buttons in Menu Mode
The buttons on the SmartDC Controller let you navigate, change, or clear the information in the display
menus. Refer to Figure 6
.
The buttons with text above and below are variable function keys (VFK). Use these buttons to enter or
change operational data and navigate through the User and Installer Menus. The singular use of a variable
function key is dependent on operator mode. Three different modes exist:
•
Run Mode - gate is operational awaiting commands. Refer to
“Using the SmartDC Controller Buttons
RUN Mode.
•
Menu Mode - motor disengages and operator commands are ignored. Data entry, menu
navigation, and menu selection can be accomplished via the Controller buttons or through a
S.T.A.R.T. software connection using the USB port.
•
Fault Mode - errors, faults or alerts appear on the display. Some errors or faults can be reset
with the STOP button while more serious faults require the RESET button or cycling power, and
then pressing RESET. Faults indicate a need for diagnosis and resolution. Refer to
Controller Troubleshooting” on page 122
�
Figure 6. Function of the SmartDC Controller Buttons in Menu Mode
Summary of Contents for FOLDSMART
