9
Power Board Replacement
The Power board of the Pulsar charger is enclosed within the plastic body of the charger. The Power
board, if malfunctioning or damaged can be replaced by performing the following steps:
Removing the old Power board
Unscrew the Torx screw at the bottom of
the charger using a Torx T9 screwdriver and
save it for later use.
Carefully remove the communications cable
from the body of the charger.
Turn off the power supply to the charger.
Using the opening tool, unclip the cover from
the charger´s body.
1.
3.
2.
4.
Ensure that the communications cable is detached
gently from the connector. Do not pull or apply
excessive force to remove the cable.
Using a screwdriver remove the power input
cables.
Remove the cables that are connected to
the Power Supply unit. Use a screwdriver to
release the cables from the connectors
5.
6.
Ensure to remember the right configuration of cables
with their respective levers. If it helps, note down the
configuration on a piece of paper for your reference.
Summary of Contents for PULSAR
Page 1: ...PULSAR Service Manual...
