ASSEMBLY INSTRUCTION
Two persons, approximately 15 minutes.
Tools required: Screwdriver PZ2, Screwdriver T30, Pallet or similar.
A
.
Place the FluidWorker on its back on a pallet or similar. Let the bottom extend outside the pallet.
B
.
Unscrew the four FluidWorker feet.
C
.
Mount the two heel brackets (1) to the bottom of the FluidWorker with the enclosed screws (2).
D
.
Raise the FluidWorker to standing position.
E
.
Attach the container holder (3) by pushing the two hooks into the outer, knee-high holes, on the
backside of the Fluidworker. Lower the container holder (3) until it folds into upright position.
F
.
Place the 30L container (4) into the container holder (3) and place the FluidWorker inlet and outlet
pipes into the container (4).
A-B-C
D-E-F
1
2
3
4
