WX520, WX520L, WX520T
Trailer Wood Splitter
Safety
Safety
11
•
Before applying pressure to the system,
make sure all components are tight, and
that lines, hoses and couplings are not
damaged.
•
Do not attempt any makeshift repairs to the hydraulic lines,
fittings or hoses by using tapes, clamps or cements. The
hydraulic system operates under extremely high pressure.
Such repairs can fail suddenly and create a hazardous and
unsafe condition.
•
Wear proper hand and eye protection
when searching for a high-pressure
hydraulic leak. Use a piece of wood
or cardboard as a backstop instead of
hands to isolate and identify a leak.
•
If injured by a concentrated high-pressure stream of
hydraulic fluid, seek medical attention immediately. Serious
infection or toxic reaction can develop from hydraulic fluid
piercing the skin surface.
•
Relieve pressure in the hydraulic system before working on
it.
2.10 Gas Engine Safety
CAUTION!
Before starting engine, review the operating and
maintenance instructions in the engine manual.
W019
• DO NOT
operate engine in an enclosed area. Exhaust gases
contain odorless and deadly carbon monoxide that can
cause death by asphyxiation.
• DO NOT
place hands or feet near moving or rotating parts.
• DO NOT
store, spill, or use gasoline near an open flame,
or devices such as a stove, furnace, or water heater which
use a pilot light or devices which can create a spark.
• DO NOT
refuel indoors where area is not well ventilated.
• DO NOT
refuel while engine is running. Allow engine to cool
for five minutes before refueling. Store fuel in approved
safety containers.
• DO NOT
remove fuel tank cap while engine is running.
• DO NOT
operate engine if gasoline is spilled. Move machine
away from the spill and avoid engine ignition until gasoline
has evaporated.
• DO NOT
smoke while filling fuel tank.
• DO NOT
choke carburetor to stop engine. Whenever
possible, gradually reduce engine speed before stopping.
• DO NOT
run engine above rated speeds. This may result in
injury.
• DO NOT
tamper with governor springs, governor links or
other parts which may increase the governed speed.
• DO NOT
tamper with the engine as set by the original
equipment manufacturer.
• DO NOT
check for spark with spark plug or spark plug wire
removed.
• DO NOT
crank engine with spark plug removed. If engine is
flooded, crank until engine starts.
• DO NOT
strike flywheel with a hard object or metal tool as
this may cause flywheel to shatter in operation. Use proper
tools to service engine.
• DO NOT
operate engine without a muffler. Inspect
periodically and replace, if necessary.
• DO NOT
operate engine with an accumulation of grass,
leaves, dirt or other combustible materials in the muffler
area.
• DO NOT
use this engine on any forest covered, brush
covered, or grass covered unimproved land unless a spark
arrester is installed on the muffler. The arrester must be
maintained in effective working order by the operator. In the
state of California, the above is required by law (Section
4442 of the California Public Resources Code). Other states
may have similar laws. Federal laws apply on federal land.
• DO NOT
touch hot muffler, engine body or cooling fins.
Contact may cause burns.
• DO NOT
run engine with air cleaner or air cleaner cover
removed.
Be sure to:
•
Remove the wire from the spark plug when servicing
the engine or equipment to prevent accidental starting.
Disconnect the (-) ground wire from the battery terminal.
•
Keep engine cooling fins and governor parts free of grass
and other debris that can affect engine speed.
•
Examine muffler periodically to be sure it is functioning
effectively. A worn or leaking muffler should be repaired or
replaced as necessary.
•
Use fresh gasoline. Old fuel can clog carburetor and cause
leakage.
•
Check fuel lines and fittings frequently for cracks or leaks.
Replace if necessary.
Summary of Contents for 250754
Page 42: ...www wallensteinequipment com...
