WX520, WX520L, WX520T
Trailer Wood Splitter
Operating Instructions
27
IMPORTANT! Engine should be warmed up before putting to
work.
6.
Once the engine is warmed, increase the throttle setting to
MAX before beginning.
6.10 Stopping the Engine
To stop the engine in an emergency, turn the ignition switch OFF.
Correct fault situation before restarting.
00187
Fig. 22 –
Ignition Switch
Under normal conditions, use the following procedure
1.
Stop loading material onto the splitter bed.
2.
Decrease engine speed to MIN.
3.
Turn the ignition switch OFF.
6.11 Log Placement
WARNING!
Risk of pinching or crushing hazard between the
wedge or push block and the log!
Never place hands at the ends of the log.
Always grasp logs by the sides when loading or
removing.
W035
• Always grasp logs by the bark side and not the ends,
when placing or removing logs from the splitter.
Minimize
the chance of getting fingers, hands or arms caught
between the push block and the log.
•
Any logs or debris remaining on the splitter bed should only
be removed after it is safe to do so.
00645
Fig. 23 –
Correct Log Placement
Summary of Contents for 250754
Page 42: ...www wallensteinequipment com...
