Operating Instructions
WX520, WX520L, WX520T
Trailer Wood Splitter
28
6.12 Splitting Wood
WARNING!
Risk of pinching or crushing hazard! The worker
loading the splitter MUST be the only one in
control of the hydraulic cylinder and splitting
wedge.
Only one worker should operate and load the
wood splitter.
W036
1.
Place wood or log on the splitter.
2.
Push control lever forward and hold to split wood.
3.
Release the lever when the log splits or cylinder reaches full
stroke and stops.
4.
Pull the lever back to retract the push block. The detent
holds the lever until the cylinder fully retracts, allowing
hands-free operation.
00644
Fig. 24 –
Hydraulic Control Valve Positions
IMPORTANT! Do not hold the valve lever to extend or
retract the cylinder once it has reached the end of its stroke.
Doing so can overheat the oil and could damage the engine.
5.
If the log is large enough to require another split, reposition
and repeat steps.
6.
Pile the split wood close to the working area, but do not
allow pieces to pile up and clutter the area. A cluttered
working area can lead to tripping and an accident.
6.13 Transporting
6.13.1 Transport Safety
1.
Comply with local laws governing safety and transporting
of machinery on public roads.
2.
Do not exceed 50 mph (80 km/h) when towing this
machine. Slow down for rough terrain and cornering.
3.
Do not transport or move the wood splitter with the engine
running.
4.
Be sure the trailer is hitched correctly to the towing vehicle
and a retainer is used through the hitch mechanism.
5.
Always attach safety chains between the hitch and the
towing vehicle. Cross the chains underneath the trailer
tongue.
6.
Check wheel lugs and tighten if required. Inspect rims for
damage.
7.
Inspect tires for cuts or damage. Check tire pressure and
adjust if required.
8.
Ensure the stability jacks are raised and secured with the
latch pin.
9.
Make sure tow vehicle is fitted with the correct size (2 in)
towing ball.
10.
Make sure fuel and hydraulic tank caps are on tight to
prevent spills while transporting.
11.
Clean all debris off the splitter. Remove any tools or other
loose items.
12.
Check that all the lights, reflectors and other lighting
requirements are installed and in good working condition.
13.
Never allow riders on the machine.
14.
Be a safe and courteous driver. Always yield to oncoming
traffic in all situations, including narrow bridges,
intersections, and so on.
15.
Watch for other traffic when near or crossing roadways.
16.
Do not drink and drive.
17.
Before transporting, perform a walk-around inspection to
ensure everything is safe.
Summary of Contents for 250754
Page 42: ...www wallensteinequipment com...
