Storing the Wood Splitter
WX520, WX520L, WX520T
Trailer Wood Splitter
30
7. Storing the Wood Splitter
After the season's use and the wood splitter is going to be
put away in storage, it should be thoroughly inspected and
prepared. Repair or replace any worn or damaged components
to prevent any unnecessary down time at the start of next
season. The wood splitter can have a long, trouble-free life by
following these steps:
IMPORTANT! Refer to the engine manufacturer's manual
for information specific to engine storage.
1.
Fully retract the cylinder ram.
2.
Add a stabilizer to the fuel tank. Top up the tank and
run the engine outdoors for 10 minutes to be sure that
treated gasoline has replaced the untreated gasoline in the
carburetor.
3.
Turn fuel valve OFF.
4.
Thoroughly wash the machine using a pressure washer to
remove all dirt, mud, debris, and residue.
5.
Inspect the cylinder ram, push block and wear plates for
damage or entangled material. Repair or replace damaged
parts. Remove all entangled material.
6.
Touch up all paint nicks and scratches to prevent rusting.
7.
If the splitter is to be stored for longer periods
(over 6 months), follow the engine manufacturers
recommendations for storage preparation.
8.
Store the machine in an area away from human activity.
9.
Select an area that is dry, level and free of debris to park the
wood splitter.
10.
If the wood splitter is not stored inside a building, cover
with a waterproof tarp. Tie securely in place.
11.
Do not allow children to play on or around the stored
machine.
7.1 Removing from Storage
1.
Review and follow the Pre-operation Checklist. See
2.
Review safety and operation procedures. See
Summary of Contents for 250754
Page 42: ...www wallensteinequipment com...
