WXR720/L, WXR740/L
Trailer Wood Splitter
Operating Instructions
27
6.9.2 WXR740, WXR740L
00201
1
2
Fig. 17 –
WXR740, WXR740L Set-up
1. Jack Stand, Snap Lock Pin
2. Jack Stand
The WXR740 Series splitters are designed with a
pivoting main frame that allows horizontal or fully
vertical splitting.
NOTE: If using a tow vehicle, leaving the splitter
attached to it provides greater stability.
1.
Position the splitter next to the wood to be split.
2.
If no tow vehicle is available, lower the front crank
jack and the rear jack stand. Chock the wheels so
the machine is stable.
3.
Make sure working area is clear of stones,
branches or other obstacles.
4.
Precut logs to desired block size, ready to load
onto splitter bed.
5.
Determine where the split wood is going to be
piled. Make sure that location does not interfere
loading splitter.
6.
To rotate the splitter to vertical, pull out the
T-handle lock and push the cylinder up.
00623
1
2
Fig. 18 –
Rotate Splitter to Vertical
6.10 Starting the Engine
CAUTION!
Before starting engine, review the operating and
maintenance instructions in the engine manual.
W019
CAUTION!
Hearing loss hazard. Prolonged
exposure to loud noise may cause
permanent hearing loss. Use suitable
protection while operating the
machine.
W016
Make sure the wood splitter is set up to work and
otherwise ready to run.
1.
If the engine is cold, close the choke (push choke
lever to the left). To start a warm engine, leave the
choke open (lever pushed to the right).
Summary of Contents for 720123
Page 43: ......
Page 44: ...www wallensteinequipment com...
