BX52R, BX72R, BX102R
Tractor Wood Chipper
Service and Maintenance
65
8.9.2 Feed Roller Maintenance on
BX102RP Models
1.
Start the tractor or power pack to energize the hydraulics.
2.
Lift the roller using the hydraulics until the locking plate pin
hole lines up with the locking pin on the clevis.
3.
Pull back, rotate and release the locking pin. Make sure
spring pulls the pin through the locking plate hole.
00885
Fig. 88 –
Locking Pin on BX102RP Models
4.
Shut off the tractor or power pack.
5.
Ensure the chipper rotor is locked and the PTO is
disengaged.
6.
The top roller is now secured and is safe to begin
maintenance.
7.
Reverse the process to lower the upper roller into place.
CAUTION!
Avoid Serious Injury. Always make sure the roller
arm locking pin is in place before beginning any
work in this area. Never rely on the hydraulic
cylinder to hold up the roller!
8.10 Electrical System – General
IMPORTANT! When assembling or replacing wire
harnesses, apply a thin coating of silicone dielectric grease
to the harness connectors.
Clean off any corrosion or loose particles, then apply a
small amount to the surfaces of the connectors where they
meet. The grease helps to stop any possibility of future
corrosion.
Reassemble the connection. Wipe off any grease that
squeezes out.
IMPORTANT! If welding on the machine becomes
necessary, protect the tractor electronics by unhooking the
chipper beforehand. Always connect the ground clamp as
close to the work area as possible.
if equipped with P3 PULSE system, sensitive electronic
components must be removed from the machine
beforehand. Welding can produce stray voltage spikes that
can damage these items.
• Disconnect and remove the P3 Display and Controller
from the machine.
• Disconnect the tractor battery. Disconnect the negative
battery cable first before disconnecting the positive
battery cable.
• Place the welder ground clamp as close to the work
area as possible. Keep the welder cables away from the
control system electrical harnesses.
