24
4�7�2� STARTING PROCEDURE
After following operating safety and preparation
procedure the chipper should be set up and ready
to run.
1.
Turn the ignition switch clockwise to the
"ON" position.
2.
Open the fuel valve and move the throttle
to its mid idle position.
3.
Close the choke if the engine is cold.
4.
Using the starting rope, start the engine.
5.
Run engine for a few minutes to allow it to
warm up.
6.
Open the choke.
7.
To get the rotor spinning, slowly move the
drive engage handle downwards, to en
-
gage the drive and start the rotor.
8.
Move the throttle to the high position, to
allow the engine to get to full speed.
9.
Start feeding material into the hopper for
chipping.
4�7�3� STOPPING PROCEDURE
1.
Stop feeding material into the hopper.
2.
Move the throttle to idle position to slow the
engine RPM. Allow 10-15 seconds for the
rotor to slow down.
3.
Disengage the drive.
4.
Turn off the ignition switch, to stop the en
-
gine and wait for all moving parts to stop.
5.
Shut off the fuel valve.
4�7�4 EMERGENCY STOPPING:
If an emergency occurs:
• disengage the drive
• shut off the engine,
•
Correct emergency situation before restarting
engine and resuming work.
Caution:
Engaging the drive too quickly
may cause the engine to stall�
Drive Engage
Instruction Label
IMPORTANT:
Be aware that
when the rotor is been dis
-
engaged, the clutch brake
automatically engages and will
stop the rotor within 5 seconds.
Caution:
Wait for all
parts to stop moving
before attempting to
access the machine in any way.
Disengage:
Handle down
"Stop Position"
Z94446
