37
Twig Breaker (BXMC34B):
The Twig Breaker is a breaker tab located on top of the discharge chute beside upper rotor housing.
The discharge paddle passes around the twig breaker and helps to break the material into smaller
pieces and turn it into mulch. Inspect the twig breaker for damage such as gouges, a bent, or missing
tooth. A damaged twig breaker should be
replaced. If the tooth is showing wear, remove
and rotate the twig breaker.
1.
Ensure the engine is off (ignition switch is off
and the fuel valve is closed).
2.
Remove the 2 bolts that hold the twig breaker
to the housing, remove the twig breaker.
3.
Reverse the steps to install the new twig
breaker.
Twig Breaker
Twig Breaker
Bolts
Discharge
chute
6�2�3 MULCHING SCREEN (BXMC34S):
The BXMC34S model is designed with a screen in the bottom of the rotor frame. The screen retains
the wood material in the rotor chamber until it is small enough to exit through the holes and drop to the
ground under the rotor.
The standard screen features 1-1/2" (38 mm) diameter round screen, for general purpose mulching.
Two optional screens are available: 3/4" (19 mm) diameter round for a finer mulch and 1-1/2" x 7.0"
(38 mm x 178 mm ) oblong hole for wet material. See Accessories section for ordering information.
There is no screen option available for the BXMC34B.
To remove the mulching screen:
1.
Ensure the engine is off (ignition
switch is off and the fuel valve is
closed).
2.
Carefully tilt the machine back,
so the hoppers are resting on
the ground and the bottom of the
machine is exposed
3.
Remove the two mounting nuts
and bolts that hold the screen into
the bottom housing.
4.
Remove the screen.
5.
Reverse steps to re-install the
screen.
Pull down to remove
mulching screen
Mounting nuts
and bolts
Mulching
Screen
