Wallenstein BXMT32G, Setup Instructions

2

BXMT32G

Chipper / Shredder

Setup Instructions

Safety

 WARNING!

Do not assemble the machine before you read 

the assembly instructions in this manual. Make 

sure that you understand the safety information 

and each step of the procedure before you 

assemble the machine.
Keep this manual with you and available 

for frequent reference as you assemble the 

machine.

 WARNING!

Use a hoist when to lift machine components 

that weigh 50 lb (23 kg) or more. Do not lift 

machine components that weigh more than you 

can lift without strain or injury.

 WARNING!

Use lift equipment with a lift capacity that 

is more than the weight of the machine 

component. Put jack stands or wood blocks 

under the machine to make it safe while you 

assemble the machine.

 WARNING!

Use the correct tools and equipment to 

assemble the machine. The use of incorrect 

tools can create safety hazards. A tool that 

breaks or slips during assembly risks personal 

injury. Repair or replace equipment or tools that 

are broken or defective.

 WARNING!

All lifting equipment (for example, straps, 

slings, chains, or ratchet blocks) must comply 

with the applicable local laws, standards, and 

regulations. Wallenstein Equipment does not 

accept responsibility for the use of unsafe 

equipment and work practices.

 WARNING!

Know the location of and keep away from 

overhead power lines and obstructions when 

you lift the machine. Contact with power lines 

can cause electrocution. Contact with overhead 

obstructions can damage the machine or 

components.

 WARNING!

Do not start or operate the machine before you 

read the Operator's Manual. Make sure that 

you fully understand all safety, operation, and 

maintenance information before you operate 

the machine.
Keep the Operator's Manual with the machine at 

all times and available for frequent reference.

 WARNING!

Make sure that all the fasteners are installed 

and torqued to the correct specifications. For 

more information, see 

Specifications on page 

13.

 CAUTION!

Keep the assembly area clean and free of debris 

to prevent slips, trips, or falls.

IMPORTANT! Inspect the machine for damage from 
shipping. Contact the shipping company immediately if you 
find any damage to the machine.

Some components are attached to the skid with 
screws. Make sure that you only discard the 
shipping brackets.
Put the crate in a large, open area so that you can 
access the machine components from all sides 
during assembly. 

Learn what the safety labels mean and know the safety 
hazards.