7.11 Twig Breaker
Inspect the twig breaker for damage, bent or missing teeth
every 50 hours.
The twig breaker is located inside the lower rotor housing.
Material in the chipper is broken up into smaller pieces as the
discharge paddles rotate past it.
A damaged or worn twig breaker should be replaced.
01128
Fig. 44 –
Twig Breaker
7.12 Fuel Filter
The fuel filter is located on the back side of the engine.
Replace
the fuel filter every 100 hours or annually
.
Allow the engine to cool before beginning.
1.
Turn the fuel supply off at the fuel shut-off valve.
2.
Remove the gear clamps on either side of the filter. Pull it
off the hoses and install a new one.
3.
Install and tighten the gear clamps. Turn the fuel supply
back on.
01132
Fig. 45 –
Engine Fuel Filter and Shut-off Valve
7.13 Electrical System
General
When assembling or replacing wire harnesses, apply a thin
coating of silicone dielectric grease to the harness connectors.
Clean off any corrosion or loose particles, then apply a small
amount to the surfaces of the connectors where they meet. The
grease helps to stop any possibility of future corrosion.
Reassemble the connection. Wipe off any grease that squeezes
out.
BXMT4224 / BXMT4238
Trailer Chipper-Shredder
Service and Maintenance
43
Summary of Contents for BXMT4224
Page 51: ......
Page 52: ...www wallensteinequipment com...