Wallenstein BXMT4224, Operator'S Manual

2.8  Being Prepared

• 

Never use the machine until the operators have been 
adequately trained in the safe operation of the machine and 
have read and completely understand: 

  - safety, operation and feature sections of this manual
  - each of the safety messages found on the safety signs 

on the machine. 

  - engine operator's manual

• 

PPE is recommended during assembly, installation, 
operation, adjustment, maintenance, repair, removal, 
cleaning, and transport. Do not allow long hair, loose fitting 
clothing or jewelry around equipment.

• 

Prolonged exposure to loud noise may 
cause permanent hearing loss! Power 
equipment with or without equipment 
attached can often be noisy enough to 
cause permanent, partial hearing loss. 

• 

Always wear hearing protection if the noise in any area you 
work in exceeds 80 dB. 

  - Noise over 85 dB on a long-term basis can cause 

severe hearing loss. 

  - Exposure to noise over 90 dB over a long-term basis 

may cause permanent, total hearing loss. 

  - Hearing loss from loud noise (from engines, chain 

saws, radios, and other such sources close to the ear) 
is cumulative over a lifetime, without hope of natural 
recovery.

• 

Clear working area of stones, branches or hidden obstacles 
that might be hooked or snagged, causing injury or 
damage.

• 

Determine where chips will be piled and ensure it does not 
interfere with safe operation of the machine 

• 

Be aware of overhead hazards: branches, cables, electrical 
wires.

• 

Use this machine only in daylight or good artificial light.

• 

Be sure machine is properly mounted, adjusted and in good 
operating condition.

• 

Perform the 

Pre-operation Checklist

 procedure before 

starting work (see 

Pre-Operation Checklist on page 26)

.

2.9  Refueling Safety

• 

Handle fuel with care. It is highly flammable.

• 

Allow engine to cool for 5 minutes before refueling. Clean 
up spilled fuel before restarting engine.

• 

Do not refuel the machine while 
smoking or fuel up near open flame or 
sparks.

• 

Fill fuel tank outdoors.

• 

Prevent fires by keeping machine clean of accumulated 
trash, grease and debris.

• 

Be sure to stop the engine prior to refueling.

• 

Do not overfill the fuel tank.

• 

If fuel is spilled, wipe it away carefully and wait until the fuel 
has dried before starting the engine.

• 

After refueling, make sure that the fuel cap is secured to 
prevent spillage.

2.10 Tire Safety

• 

Failure to follow proper procedures when mounting a tire on 
a wheel or rim can produce an explosion which may result 
in serious injury or death.

• 

Do not attempt to mount a tire unless you have the proper 
equipment and experience to do the job.

• 

Have a qualified tire dealer or repair service perform 
required tire maintenance.

• 

When replacing worn tires, make sure they meet the 
original tire specifications. Never undersize.

2.11 Battery Safety

 CAUTION!

Risk of burns! Battery electrolyte is extremely 

corrosive and poisonous. Contact with the eyes, 

skin, or clothing can result in severe burns or 

other serious personal injury. If contact occurs 

seek medical attention immediately. Handle 

batteries carefully. 

W020

• 

Wear gloves and safety glasses or face shield when 
working on or near batteries.

• 

Use a battery carrier to lift the battery or place hands at 
opposite corners to avoid spilling acid through the vents.

• 

Avoid contact with battery electrolyte: 

BXMT4224 / BXMT4238
Trailer Chipper-Shredder

Safety

9

 Safety