16
BXTR6438
9. Caution!
Risk of injury from flying objects. Stay
clear of material discharge chute.
Machine can expel wood chips fast
enough to cause injury.
Do not point discharge at people,
animals, or buildings.
10. Warning!
Rotating parts are exposed or under a
guard. Do not attempt to reach in while
parts are rotating.
Keep hands, loose clothing, and long
hair away. Seri ous injury can result.
11. Warning!
Risk of explosion.
Do not jump start / charge a frozen
battery. Frozen batteries can explode
and result in serious injury. Let battery
thaw before charging.
!
0°
12. Warning!
PPE is required when operating this machine.
•
A hard hat
•
Hearing protection
•
Protective glasses, goggles or face
shield
•
Protective shoes with slip resistant soles
•
Heavy gloves
Failure to wear PPE can result in personal
injury.
IMPORTANT! If parts are replaced that have safety signs on
them, new signs must be applied. Safety signs must always
be replaced if they become damaged, are removed, or
become illegible.
Safety signs are available from your authorized dealer.
Replacing Damaged Safety Signs
•
Always keep safety signs clean and legible.
•
Replace safety signs that are missing or have become
illegible.
•
Parts that were replaced with a safety decal on them must
also have the safety sign replaced.
•
Replacement safety signs are available from your
authorized Distributor, Dealer Parts Department, or
Wallenstein Equipment.
Procedure
1.
Be sure that the installation area is clean and dry.
2.
Be sure temperature is above 50 °F (10 °C).
3.
Determine exact position before removing from the backing
paper.
4.
Pull the decal off the backing sheet, align the sign over
the specified area, then carefully press the exposed sticky
backing in place.
5.
Use a piece of the backing paper to smooth the decal out,
pressing from the center outwards.
6.
Small air pockets can be pierced with a pin and smoothed
out using the piece of sign backing paper.
