5.7 Moving, Swinging the Conveyor
Sideways
•
Unload the conveyor. Allow it to operate until all the split
wood has cleared. If equipped with the power pack option,
shut the engine down. Shut down the wood processor.
•
Lower the conveyor down to the stops on the frame.
•
Remove the blocks and rotate the wheels. See
for instructions on wheel rotation.
•
Push the conveyor to the new position.
•
Block the wheels.
•
Check the position of the hopper end of the conveyor.
Make sure it is placed so split wood falls properly from the
processor discharge chute.
•
Reposition conveyor hopper if required, then drive a 1/2"
(12 mm) steel rod (not supplied) through the hitch into the
ground to anchor it there.
01849
Fig. 18 –
Steel Rod through Conveyor Hitch
Operating Instructions
CT24
Trailer Firewood Conveyor
22
