6.5 Pre-operation Checks
Efficient and safe operation of the Wood splitter requires that
each operator reads and understands the operating procedures
and all related safety precautions outlined in this section. It is
important for both the personal safety and maintaining good
mechanical condition of the machine that this checklist is
followed.
1.
Lubricate the wood splitter before using it.
2.
Make sure the skid steer is of adequate power and weight
to operate the wood splitter. See page 19.
3.
Check that the wood splitter is properly attached to the skid
steer. Be sure the lock pins on the loader face plate are fully
engaged to secure the wood splitter to the loader.
4.
Check the oil level in the skid steer hydraulic reservoir. Add
as required.
5.
Check the condition of all hydraulic lines, hoses, and
fittings. Replace any that are damaged. Re-route those that
are rubbing, pinched or crimped. Tighten any fitting that is
leaking.
6.
Check and remove any entangled material.
7.
Install and secure all guards, doors and covers before
starting.
8.
Review the
Controls
section in your skid steer operator's
manual. Be familiar with the control settings and functions
before operating wood splitter.
6.6 Splitter Operation
Safety Rules
• Do not operate on slopes or side hills.
• Keep all mechanical and hydraulic components in
good condition. Do not operate with leaks or damaged
components.
• Clear the area of bystanders.
• Place skid steer drive system in neutral before
beginning.
• Do not split wood across the grain.
• Keep your working area clear to prevent tripping.
6.7 Splitting Logs
IMPORTANT! Park the wood splitter on a level, dry work
area free of debris and other objects.
Position the splitter so the prevailing wind blows engine
exhaust away from the operator.
1.
Make sure working area is clear of stones, branches or
other obstacles.
2.
Precut logs to desired block size, ready to load onto splitter
bed.
3.
Determine where the split wood is going to be piled. Make
sure that location does not interfere loading splitter.
4.
Move skid steer into and splitter into a working position,
set the splitter to a comfortable work height. Apply the park
brake.
5.
Move the throttle to its mid-range position. Place the
working hydraulic circuit in detent.
6.7.1 Log Placement
WARNING!
Risk of pinching or crushing hazard between the
wedge or push block and the log!
Never place hands at the ends of the log.
Always grasp logs by the sides when loading or
removing.
W035
• Always grasp the log by the sides not the ends when
placing in or removing logs from the splitter.
This
minimizes the chance of getting fingers, hands or an arm
between the wedge and the log.
WARNING!
Risk of pinching or crushing hazard! The worker
loading the splitter MUST be the only one in
control of the hydraulic cylinder and splitting
wedge.
Only one worker should operate and load the
wood splitter.
W036
WX470
Skid Steer Wood Splitter
Operating Instructions
21
Summary of Contents for WX470
