WX520, WX520L, WX520T
Trailer Wood Splitter
Operating Instructions
29
6.12 Splitting Wood
WARNING!
Risk of pinching or crushing hazard! The worker
loading the splitter MUST be the only one in
control of the hydraulic cylinder and splitting
wedge.
Only one worker should operate and load the
wood splitter.
W036
1.
Place wood or log on the splitter.
2.
Push control lever forward and hold to split wood.
3.
Release the lever when the log splits or cylinder
reaches full stroke and stops.
4.
Pull the lever back to retract the push block. The
detent holds the lever until the cylinder fully retracts,
allowing hands-free operation.
00644
Fig. 25 –
Hydraulic Control Valve Positions
IMPORTANT! Do not hold the valve lever to extend
or retract the cylinder once it has reached the end of
its stroke. Doing so can overheat the oil and could
damage the engine.
5.
If the log is large enough to require another split,
reposition and repeat steps.
6.
Pile the split wood close to the working area, but
do not allow pieces to pile up and clutter the area.
A cluttered working area can lead to tripping and an
accident.
6.13 Transporting
6.13.1 Transport Safety
1.
Comply with local laws governing safety and
transporting of machinery on public roads.
2.
Do not exceed 50 mph (80 km/h) when towing this
machine. Slow down for rough terrain and cornering.
3.
Do not transport or move the wood splitter with the
engine running.
4.
Be sure the trailer is hitched correctly to the towing
vehicle and a retainer is used through the hitch
mechanism.
5.
Always attach safety chains between the hitch and
the towing vehicle. Cross the chains underneath the
trailer tongue.
6.
Check wheel lugs and tighten if required. Inspect rims
for damage.
7.
Inspect tires for cuts or damage. Check tire pressure
and adjust if required.
8.
Ensure the stability jacks are raised and secured with
the latch pin.
9.
Make sure tow vehicle is fitted with the correct size
(2 in) towing ball.
10.
Make sure fuel and hydraulic tank caps are on tight to
prevent spills while transporting.
11.
Clean all debris off the splitter. Remove any tools or
other loose items.
12.
Check that all the lights, reflectors and other lighting
requirements are installed and in good working
condition.
13.
Never allow riders on the machine.
14.
Be a safe and courteous driver. Always yield to
oncoming traffic in all situations, including narrow
bridges, intersections, and so on.
15.
Watch for other traffic when near or crossing
roadways.
16.
Do not drink and drive.
17.
Before transporting, perform a walk-around inspection
to ensure everything is safe.
Summary of Contents for WX520L
Page 1: ...OPERATOR S MANUAL TrailerWoodSplitter WX520 L WX520T Part Number Z97135_En Rev May 2019...
Page 42: ......
Page 43: ......
