Controls
WX520, WX520L, WX520T
Trailer Wood Splitter
22
5.3 Stroke Limiter Accessory
The Stroke Limiter accessory improves productivity when
splitting shorter pieces. It stops the cylinder from fully
returning to the home position.
5.3.1 Stroke Limiter – Adjustment
1.
Place a typical sized log on the splitter bed, then start
/ apply power to the wood splitter.
2.
Using the hydraulic control, move the push block up
to the log, but stop approximately 3" (8 cm) from it.
3.
Shut off the engine. Make sure the hydraulic control
lever is in the neutral position.
4.
Loosen the hex set screw on the rod adjusting collar,
and move the rod up to the push block. (This is the
set position at which the push block stops on the
return cycle.) Tighten the hex screw.
5.
Test the set up by cycling the push block through
its path. Split a log then put the hydraulic lever into
the return (detent) position. The lever should trip the
hydraulic control and the anvil / ram stops at the set
position. Adjust as required.
00713
3"
(8 cm)
Fig. 14 –
Splitter Stroke Limiter
Summary of Contents for WX520L
Page 1: ...OPERATOR S MANUAL TrailerWoodSplitter WX520 L WX520T Part Number Z97135_En Rev May 2019...
Page 42: ......
Page 43: ......
