WX520, WX520L, WX520T
Trailer Wood Splitter
Operating Instructions
25
6.5 Engine Oil Level Check
Check engine oil level daily.
Check with the machine parked on level ground and the
engine stopped.
IMPORTANT! Running the engine with a low oil
level can cause engine damage that is not covered
by warranty.
1.
Remove the oil level dipstick and wipe it clean.
2.
Fully insert the oil level dipstick, then remove it to
check the oil level.
The proper level is when the oil
is visible at the full (upper) mark on the dipstick.
3.
If the oil level is low, add oil until the level is at the full
mark.
SAE 10W-30 is recommended for general use.
4.
Reinstall the oil level dipstick.
2
1
00667
Fig. 15 –
Engine Oil Level check
1. Oil Level Dipstick
2. Oil Filler
Refer to the engine owner's manual included in the
manual tube for further information on engine oils
.
6.6 Hydraulic Oil Level Check
Check hydraulic oil level every 40 hours or weekly.
Check with the machine parked on level ground and the
engine stopped.
The proper level is when the oil is visible at the full
(upper) mark on the dipstick.
00638
Fig. 16 –
Hydraulic Tank Oil Level Dipstick
IMPORTANT! Do not operate machine if oil level is
not visible on the dipstick. Damage to the pump and
other components can occur.
Do not overfill the tank past the full mark.
Always check oil levels after changing filters or
servicing hydraulic components.
Hydraulic oil quality should be inspected every
40 hours. If the oil is dirty or smells burnt, it should
be replaced.
Be aware of high oil temperatures. Temperatures
higher than 180 °F (82 °C) could cause seal damage
and degrade oil quality.
6.6.1 Hydraulic Oil – Adding
The hydraulic system uses
Dexron® III ATF
.
1.
Clean the area around filler cap and remove it.
2.
Use a clean funnel and add oil until the level is at the
full mark on the dipstick.
3.
Install filler cap securely. Wipe up any spilled oil.
Summary of Contents for WX520L
Page 1: ...OPERATOR S MANUAL TrailerWoodSplitter WX520 L WX520T Part Number Z97135_En Rev May 2019...
Page 42: ......
Page 43: ......