Operating Instructions
WX520, WX520L, WX520T
Trailer Wood Splitter
28
IMPORTANT! Engine should be warmed up before
putting to work.
6.
Once the engine is warmed, increase the throttle
setting to MAX before beginning.
6.10 Stopping the Engine
To stop the engine in an emergency, turn the ignition
switch OFF. Correct fault situation before restarting.
00187
Fig. 23 –
Ignition Switch
Under normal conditions, use the following procedure
1.
Stop loading material onto the splitter bed.
2.
Decrease engine speed to MIN.
3.
Turn the ignition switch OFF.
6.11 Log Placement
WARNING!
Risk of pinching or crushing hazard between the
wedge or push block and the log!
Never place hands at the ends of the log.
Always grasp logs by the sides when loading or
removing.
W035
• Always grasp logs by the bark side and not the
ends, when placing or removing logs from the
splitter.
Minimize the chance of getting fingers,
hands or arms caught between the push block and
the log.
•
Any logs or debris remaining on the splitter bed
should only be removed after it is safe to do so.
00645
Fig. 24 –
Correct Log Placement
Summary of Contents for WX520L
Page 1: ...OPERATOR S MANUAL TrailerWoodSplitter WX520 L WX520T Part Number Z97135_En Rev May 2019...
Page 42: ......
Page 43: ......
