Controls
WX900 Series
Log Splitter
18
5.2.1 Splitter Control
00644
1
2
3
Figure 9 –
Splitter-control valve
1. Extend
2. Stop
3. Retract
Extend position
•
Push the splitter-control lever forward to move the wedge
toward the log. Hold the lever forward to split the wood.
•
Releasing the lever returns it to the stop position.
Stop Position
•
The stop position is when the splitter-control valve is in
neutral. The wedge or push block stops moving when the
lever is moved to this position. The valve lever spring-
returns to the stop position when released from either the
extend position or retract position.
•
The splitter-control lever can be moved to stop at any time.
Retract Position
•
Pull the lever fully backwards to retract the wedge. The
splitter-control valve holds the lever in retract allowing a
hands-free return cycle.
•
The valve lever returns to the stop position when wedge or
push block is fully retracted.
•
The lever can be moved out of the retract position and into
the stop position at any time.
5.2.2 Log Lifter Shelf Control
00656
1
2
3
Figure 10 –
Log lifter shelf control valve
1. Lower
2. Stop
3. Lift
Lower position
•
Push the log lifter shelf control lever forward to lower the
log lifter shelf. Hold the lever forward to lower the log lifter
shelf to its lowest position.
•
Releasing the lever returns the lever to the stop position.
Stop Position
•
The stop position is when the log lifter shelf control valve is
in neutral. The shelf stops moving when the lever is moved
to this position. The valve lever spring-returns to the stop
position when released from either the lower position or lift
position.
•
The log lifter shelf control lever can be moved to stop at
any time
Lift Position
•
Pull the log lifter shelf control lever fully backwards to lift
the log lifter shelf. Hold the lever backwards to lift the log
lifter shelf to its highest position.
•
Releasing the lever returns the lever to the stop position.
Summary of Contents for WX900 Series
Page 48: ...WallensteinEquipment com...
